Mon–Fri 9am–5pm  ·  Emergency After-Hours Service Availableinfo@appliancerepairmasters.com

Dryer Vent Cleaning

Dryer Vent Cleaning

Dryer Vent Cleaning That Clears the Whole Duct

Dryer vent cleaning removes the lint packed inside your duct run so the dryer can push moisture outside again. We run a 50-foot brush line through the entire duct, then run a cycle and check airflow at the outside vent before we leave.

  • $15 Off Vent Cleaning
  • Licensed & Insured
  • 12 Years on Dryers Only
Technician removing lint buildup from a clogged dryer vent

What dryer vent cleaning actually removes

Every load pushes lint through the vent line. The lint trap catches some of it. The rest travels down the duct, and wherever the air slows — at an elbow, a sag in flexible hose, a long horizontal run — it settles and builds a layer.

South Florida makes it worse. Humid air means longer drying cycles, and longer cycles push more lint through. Condo buildings along the coast were built with long horizontal duct runs to exterior walls, sometimes forty feet or more, and many have never been cleaned. Homes in the western suburbs vent up through the attic to a roof cap, where flexible duct sags between supports and collects lint at every low point.

Once airflow drops, the dryer cannot exhaust moisture. Clothes stay damp, cycles run twice, and the machine runs hotter than it was designed to.

Signs your dryer vent needs cleaning

Clothes need more than one cycle

The clearest sign, and usually the first one people notice.

The dryer or laundry room is hot after a cycle

Heat that should be leaving through the vent is staying in the room.

The outside vent flap barely moves

Strong steady airflow should push it open. Weak movement means a restriction.

A musty smell in the laundry area

Moisture that is not venting is condensing inside the duct.

Lint around the vent hood or behind the dryer

What escapes at either end is a fraction of what is inside the run.

The dryer shuts off mid-cycle

Overheating from restricted airflow trips the high-limit thermostat.

A burning smell

Stop using the dryer and call. Lint against a heating element is how dryer fires start.

The dryer shows an airflow or heating code

LG reports duct blockage as a percentage. Samsung lists a clogged vent as the most common cause of its heating codes. See dryer error codes by brand.

How we clean a dryer vent

Most residential cleanings take under an hour. Long condo runs and attic-to-roof runs take longer.

Inspect first

We look at the transition duct, the wall opening, and the exterior hood before touching anything, so we know what kind of run we are dealing with.

Pull and disconnect

The dryer comes forward and the transition duct comes off. That gives us the full vent line and lets us check the transition hose, where a lot of lint collects.

Run the brush line

A 50-foot brush driven by a drill. It rotates as it travels, so it scrubs the duct wall along the entire run instead of pushing a plug of lint further in.

Clear the exterior hood

The hood is where lint packs hardest. We clear it and check that the damper still opens and closes freely.

Check the duct material

We tell you what your concealed run is made of. Foil or plastic in a hidden run will re-clog faster and should be replaced.

Verify airflow

We reconnect, run a cycle, and confirm strong steady flow at the outside vent. You see the difference before we leave.

Can you clean a dryer vent yourself?

Partly. A hardware-store brush kit will clear the first few feet from the wall opening, and that is worth doing between professional cleanings.

The problem is where the lint actually sits. On a twenty-foot run it collects in the middle, at the elbows, and at the exterior hood — past the reach of a short kit and well past the reach of a shop vac held at the opening. Clearing the first few feet can also push a plug of lint further down the duct, which makes the restriction worse rather than better.

Three situations where a professional is the only realistic option: the run terminates on the roof, the run is longer than about fifteen feet, or the dryer is a stacked unit in a closet that has to come out before anything can be reached.

Between cleanings, the useful habits are simple. Clear the lint screen after every load. Once in a while, run water over the screen — if it beads up instead of passing through, fabric softener has filmed it over and it needs scrubbing. And leave a few inches of clearance behind the dryer so the transition duct is not crushed flat.

What happens if a clogged vent is left alone

The dryer keeps working, which is why this gets ignored. What changes is how hard it works.

The appliance wears out faster. A dryer fighting a blocked duct runs longer and hotter every cycle. Heating elements, cycling thermostats, and thermal fuses are the parts that fail from that, and they fail repeatedly until the airflow is fixed. A thermal fuse that blows twice is not a bad part, it is a symptom.

Energy costs rise. Two cycles instead of one, on every load.

Moisture goes somewhere it should not. A dryer moves a large amount of water vapor. If it cannot leave through the duct, it condenses inside it — or worse, inside a wall or attic if the run is damaged.

Fire risk rises. Lint is combustible and a restricted vent makes the dryer run hotter. Those two conditions together are the mechanism. More on the warning signs: dryer vent fire risk signs.

What the service includes

Included: pre-clean inspection · transition duct cleaning · full-length duct cleaning with the 50-foot brush line · exterior vent hood clearing · damper check · duct material assessment · reconnection · airflow verification · cleanup

Not included: duct repair or replacement (see dryer vent installation) · appliance repair (see dryer repair) · roof access where a roof cannot be walked safely

If we find crushed duct, disconnected sections, or foil hose in a concealed run, we show you and quote it separately. We will not clean around a problem and leave it there.

Dryer vent hood before and after professional cleaning

Why a dryer company and not a duct company

Most companies offering dryer vent cleaning in South Florida do air ducts, carpets, or HVAC as their main business. Vent cleaning is an add-on.

That matters when the vent is not actually the problem. Slow drying can come from the duct, a failing heating element, a coated moisture sensor, or a thermostat that keeps tripping. A duct company can clean your vent and leave the real fault in place. We work on dryers and dryer venting only, so we can tell you which one it is and fix either.

  • Dryers and dryer venting only, twelve years
  • 50-foot drill-driven brush line, full duct length
  • Airflow verified before we leave
  • Licensed and insured
  • Same or next day scheduling
  • Residential and commercial
Lint accumulation inside a dryer transition duct

Pricing and guarantee

How our pricing works

$99 diagnostic, waived when you approve the work. We assess the run first, tell you what it needs, and the diagnostic comes off the bill when you go ahead.

$15 off dryer vent cleaning. Mention it when you call.

After-hours emergency service. Outside regular business hours a $150 emergency fee applies. It is non-refundable and charged in addition to the diagnostic fee.

Work is backed by our 90-day parts and labor guarantee. Extended warranty coverage is available for purchase.

Where we clean dryer vents

Full-length dryer vent cleaning across Broward and Palm Beach County.

Dryer Vent Cleaning FAQ

How long does dryer vent cleaning take?

Most residential vents take under an hour. A long condo run or an attic-to-roof run takes longer, and a stacked unit that has to come out of a closet adds time on both ends.

How often should a dryer vent be cleaned?

Once a year for a typical household. More often with a large family, pets, a long duct run, or flexible foil ducting. Full breakdown: how often to clean a dryer vent.

Do you clean the whole vent or just the opening?

The whole run. The brush line is 50 feet and drill-driven, so it travels the full duct length rather than stopping a few feet in at the wall. We also clear the exterior hood and check the damper.

Can I just use a shop vac at the wall?

It clears the first few feet. The buildup that actually restricts airflow usually sits in the middle of the run or at the exterior hood, and a vac at the opening never reaches it.

Will cleaning fix my slow drying?

If the duct is the restriction, yes, and usually back to a single cycle. If the dryer itself has a failing heating element, thermostat, or moisture sensor, cleaning will not change anything. We check airflow so you know which one you have before paying for the wrong fix.

Do you clean vents in condos and apartments?

Yes, including long horizontal runs and stacked units in closets. If your building requires HOA notice or a certificate of insurance on file, tell us when you call and we will arrange it.

What if the duct is damaged?

We show you and quote a repair or replacement separately. Foil or plastic hose in a concealed run should be replaced with rigid metal — see dryer vent installation.

Does a clogged vent really cause fires?

Lint is combustible and a restricted vent makes the dryer run hotter than designed. Those two conditions together are the mechanism. More: dryer vent fire risk signs.

Get Your Dryer Vent Cleaned

Full-length cleaning with airflow verified before we leave. Same or next day across Broward and Palm Beach County.

Mon–Fri 9am–5pm  ·  Emergency after-hours available

Call (954) 543-8795Request Service